Technical Information 40.2010 Page 19
TI_40_2010_13_01_02.fm
9.1.2 Engine does not start in position }
Is it possible to start
the engine?
Troubleshooting completed
Mechanically check start detection
(
b 9.6.1)
Clean switch gear
replace if necessary
Electrically check start detection
(
b 9.6.2)
yes
Mechanically
OK?
Are target values
attained?
Look for a fault in the fuel path
(inlet needle, lever, spring,
membrane),
check engine for leaks
Replace switch gear if necessary
yes
no
no
Engine does not start in position
} –
engine floods. The flooded engine can
be started in position F
yes
no
To Next Page
Loading...
