FS 510 C-M, FS 560 C-M
English
31
If the cutting attachment rotates when
the engine is idling, refer to notes in
chapter on "Adjusting the Thottle Cable"
or have the machine serviced by your
dealer. STIHL recommends a STIHL
servicing dealer.
N Attach the machine to the shoulder
strap.
N Machine is ready for use.
Stopping the Engine
N Depress the momentary contact
stop switch – the engine stops –
release the stop switch – it springs
back to the run position.
Other Hints on Starting
Starting for first time
N Depress the throttle trigger – do not
press down the throttle trigger
lockout.
If engine speed increases or the cutting
attachment rotates:
N Go to section "Stopping the
Engine".
N Go to "Adjusting the Throttle Cable".
If the engine speed does not increase,
your machine is ready for operation.
At very low outside temperatures
N Set the engine to winter operation if
necessary, see "Winter Operation".
N If the machine is very cold (frost on
machine), allow the engine to warm
up in the Start } position after
starting until normal operating
temperature is reached. Warning:
the cutting attachment rotates in this
position.
At very high outside temperatures
If the engine does not start after 10 pulls
in the Start } position:
N Start the engine in the Run F
position.
If the engine does not start
N Check that all settings are correct.
N Check that there is fuel in the tank
and refuel if necessary.
N Check that the spark plug boot is
properly connected.
N Repeat the starting procedure.
Fuel tank run until completely dry
N After refueling, press the fuel pump
bulb at least five times – even if the
bulb is filled with fuel.
N Start the engine.
To Next Page
Loading...
