Stihl HSE 61

16 HSE 61, HSE 71, HSE 81
4.1.2 Mounting the cutting
attachment
Up to serial number 9 72 393 577
: Place the cutting attachment (1)
on the gear housing (2).
– Engage the lower blade on the
lower connecting rod (3).
: Line up holes in cutting
attachment with holes in gear
housing (2) and insert the screws
(4) but do not finally tighten yet.
: Engage the upper blade (1) on
the upper connecting rod (2).
1
4
4
3
2
2
1
: Tighten down the screws (1)
firmly (2.9 Nm).
: Check that the pin (1) is fitted in
the cover (2). If the pin (1) is not
in the cover (2), fit it as shown in
the illustration.
b 4.1.1
1
1
1
2
From serial number 9 72 393 578
: Place the cutting attachment (1)
on the gear housing (2).
– Engage the lower blade on the
lower connecting rod (3).
: Line up holes in cutting
attachment with holes in gear
housing (2) and insert the screw
(4) but do not finally tighten yet.
: Engage the upper blade (1) on
the upper connecting rod (2).
2
1