0458-698-8621-A
31
English
14 Assembling the Pole Pruner
To mount the guide bar and chain:
► Switch off the pole pruner, @ 16.2.
► Remove the battery, @ 15.2.
► Turn the nut (1) counterclockwise until the chain sprocket
cover (2) can be removed.
► Remove the chain sprocket cover.
► Turn the side chain tensioner (3) counter-clockwise until
the tensioning gear (4) sits flush against the housing.
► Position the chain in the groove of the guide bar, starting
at the tip.
► Make sure that the cutters in the groove on the top side of
the guide bar face the tip of the bar. STIHL chains are
manufactured with arrows on the tie straps to help the
operator determine the proper direction of the chain.
Arrows on the tie straps on the top of the bar must point
toward the bar tip.
► Point the guide bar tip away from the chain sprocket (7).
► Place the chain around the chain sprocket.
► Slide the guide bar (6) over the collar screw (5). The head
of the collar screw must protrude into the oblong hole.
► Fit the pin of the tensioning gear in the hole (8) of the
guide bar.
► Direct the drive links into the groove of the guide bar (6,
arrow) while turning the side chain tensioner (3) clockwise
until it stops.
The guide bar and chain must be firmly and securely
mounted on the pole pruner.
► Fit the sprocket cover on the pole pruner so that it is flush
with the housing.
► Turn the nut clockwise until the chain sprocket cover is
firmly attached to the pole pruner.
14.6.2 Removing the Guide Bar and Chain
► Unscrew the nut securing the chain sprocket cover.
1
2
3
4
0000097170_001
0000097172_001
6
3
To Next Page
Loading...
Need help?
General
