0478-404-9604-A
57
English
6 Assembling the Cultivator
Attaching the blade spur
► Insert the adapter with attached blade spur (7) into
mount (8) on the tiller.
► Insert pin (9).
► Push retaining pin (10) through the bore in pin (9).
► Screw in screws (11) and tighten firmly.
The blade spur is secured.
6.5 Attaching the Handlebar
► Fit lower handlebar (1) onto mount (2) and align locating
lug (3) with centre position (4).
► Screw pin (5) into locating lug (3) and tighten.
► Push anti-dust protection (6) downwards so that locating
lug (3) is covered.
► Screw in screw (7).
Lower handlebar (1) is locked in place.
► Press lever (8) downwards and hold.
► Insert upper handlebar (9) with bolts (10) through lower
handlebar (1) from below.
► Release lever (8) and allow upper handlebar (8) to
engage at centre detent (11).
► Place washers (12) and nuts (13) on bolts (10).
To Next Page
Loading...
