0478-404-9604-A
68
English
11 Working with the Cultivator
► Loosen screws (1).
► Detach retaining pin (2) and remove pin (3).
► Move blade spur (4) into the desired position.
► Insert pin (3).
► Push retaining pin (2) through the bore in pin (3).
► Tighten screws (1) firmly.
11.3 Using the PTO Drive
► Stop the engine.
► Unscrew screws (1).
► Remove cover (2).
The screws (1) remain attached to cover (2).
Switching the PTO drive on
WARNING
The engine is running if the PTO drive is in use. If a gear is
engaged, the tiller may inadvertently start moving. This may
result in serious injury to people or the tiller running them
over.
► Do not press the clutch lever for reverse gear.
► Do not engage gears 1 and 2.
► Start the engine.
► Set the gear lever to position 0/R.
► Unlock, press and hold the clutch lever for self-propulsion.
► Adjust the engine speed using the throttle lever.
The PTO rotates at the set speed.
Switching the PTO drive off
► Release the clutch lever for self-propulsion.
► If the PTO drive is no longer needed:
► Stop the engine.
► Attach the cover.
11.4 Switching the Headlamp On and Off
► Press switch (1) on light switch (2).
The headlamp comes on.
► Press switch (3) on light switch (2).
The headlamp is switched off.
To Next Page
Loading...
