148 MS 261, MS 261 C
No. Description Part No. Application Rem.
17 Service tool ZS (set)
including
drilled plate 5910 893 2103
5910 007 2201 Removing and installing
crankshaft (ignition side)
- Drilled plate
to supplement service tool ZS
(set) 5910 007 2200
5910 893 2103 Pulling two halves of crankcase
together
- Screw sleeve 5910 893 2420 Installing crankshaft
18 Service tool AS (set) 5910 007 2205 Removing and installing
crankshaft (clutch side)
- Screw sleeve 5910 893 2409 Pulling two halves of crankcase
together
19 Clamping strap for assembly
stand
5910 850 1650 Clamping machine to assembly stand
20 Ignition system tester, ZAT 4 5910 850 4503 Testing ignition system
21 Ignition system tester, ZAT 3 5910 850 4520 Testing ignition system
22 Torque wrench 5910 890 0302 0.5 to 18 Nm
23 Torque wrench 5910 890 0312 6 to 80 Nm
24 Installing tool 10 5910 890 2210 Installing hookless snap rings in piston
25 Screwdriver bit, T 27 x 150 5910 890 2400 IS-P screws
26 Hook 5910 890 2800 Detaching springs on clutch shoes
27 Assembly stand 5910 890 3100 Holding saw for repairs
28 Puller 5910 890 4400 Removing oil seals
- Jaws (No. 3.1) 0000 893 3706 Removing oil seal(s)
29 Stud puller M8 5910 893 0501 Removing bar mounting studs
30 Socket, 13 mm, long 5910 893 2804 Removing and installing
decompression valve
31 Setting disk 5910 893 6600 Add-on for screwdriver (adjusting
carburetor)
32 Hook 5910 893 8800 Removing pickup body
Remarks:
1) Use for releasing only.