0458-786-0121-A
30
English
11 Operating the Saw
► Position the saw so that the felling notch is an right angles
to the direction of fall and the saw is close to the ground.
► Make the horizontal cut.
► Make the angle cut at 45° to the horizontal cut.
► If the wood is sound and long-fibered: Observe the
following points when making sapwood cuts:
– The cuts must be the same at both sides.
– The cuts must be at same height as bottom of felling
notch.
– The width of the cuts is 1/10 of the trunk diameter.
The trunk does not splinter when the tree falls.
11.9.5 Plunge cutting
Plunge cutting is a technique required for felling.
► Begin cut with the lower portion of the guide bar nose –
with chain running at full speed.
► Cut until depth of kerf is twice the width of the guide bar.
► Swing the saw into plunge-cutting position.
► Perform the plunge cut
11.9.6 Selecting the Appropriate Felling Cut
The choice of appropriate felling cut depends on the
following conditions:
– The natural inclination of the tree
– The tree’s branch formation
– Damage to the tree
– The tree’s state of health
– If there is snow on the tree: the snow load
– The direction of slope
– Wind direction and speed
– Nearby trees, if any
There are different features of these conditions. Only two
features are described in this Instruction Manual.
0000-GXX-1249-A0
To Next Page
