0458-786-0121-A
33
English
12 After Finishing Work
► Apply the spiked bumper behind the holding strap at the
same height as the felling cut and use it as a pivot.
► Hold the saw horizontally and swing it into the felling cut
as far as possible.
► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of holding strap.
► Move to the other side of the tree.
► Apply the spiked bumper behind the hinge at the same
height as the felling cut and use it as a pivot.
► Hold the saw horizontally and swing it into the felling cut
as far as possible.
► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of holding strap.
► Shout a warning.
► With arms outstretched, cut through the holding strap from
outside at a downward angle.
The tree falls.
12.1 After Finishing Work
► Shut off the engine and engage the chain brake.
► Allow chainsaw to cool down
► If the saw is wet: Allow the saw to dry.
► Clean the saw.
► Clean the air filter.
► Clean the bar and chain.
► Loosen nuts on the chain sprocket cover.
► Turn the tensioning screw two full turns counterclockwise.
The chain is now slack.
► Tighten down nuts on the chain sprocket cover.
► Fit the scabbard so that it completely covers the guide bar.
13.1 Transporting the Chainsaw
► Shut off the engine and engage the chain brake.
► Fit the scabbard so that it completely covers the guide bar.
► Carry the saw by holding the front handle in your right
hand with the guide bar pointing to the rear.
► Transporting the saw in a vehicle: Secure the saw to
prevent turnover and movement.
14.1 Storing the Chainsaw
► Shut off the engine and engage the chain brake.
0000-GXX-1260-A0
3.
2.
1.
5.
6.
4.
12 After Finishing Work
13 Transporting
14 Storing
To Next Page
Loading...
