0458-786-0121-A
34
English
15 Cleaning
► Fit the scabbard so that it completely covers the guide bar.
► Observe the following points when storing the saw:
– Saw is out of the reach of children.
– The saw is clean and dry.
If you store the saw for more than 3 months:
► Remove the bar and chain.
► Open the fuel tank cap.
► Drain the fuel tank.
► Close the fuel tank.
► Have fuel tank cleaned by a STIHL servicing dealer.
► Start the engine, engage the chain brake and run the
engine at idling speed until it stops.
15.1 Cleaning the Saw
► Shut off the engine and engage the chain brake.
► Allow chainsaw to cool down
► Clean the saw with a damp cloth or STIHL resin solvent.
► Clean cooling air slots with a soft brush.
► Rotate the shroud fasteners (1) a quarter turn
counterclockwise.
► Remove the shroud (2).
► Remove the chain sprocket cover.
► Use a soft brush, damp cloth or STIHL resin solvent to
clean the cylinder funs and the inside of the shroud.
► Clean the area around the sprocket with a damp cloth or
STIHL resin solvent.
► Place the shroud (2) in position.
► Rotate the shroud fasteners (1) clockwise until you hear a
click.
The shroud fasteners are locked.
► Fit the chain sprocket cover.
15.2 Cleaning the Bar and Chain
► Shut off the engine and engage the chain brake.
► Remove the bar and chain.
► Clean the oil port (1), oil inlet hole (2) and bar groove (3)
with a soft brush or STIHL resin solvent.
► Clean the saw chain with a soft brush or STIHL resin
solvent.
► Mount the bar and chain.
15.3 Cleaning the Air Filter
Very fine dust can collect in the air filter. The dust can clog
the filter and cannot be removed by brushing or knocking
out. The air filter must be cleaned with a cleaning agent.
► Shut off the engine and engage the chain brake.
15 Cleaning
To Next Page
Loading...
