EasyManua.ls Logo

Stihl MS 462 - Cleaning the Spark Plug

Stihl MS 462
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
0458-786-0121-A
35
English
15 Cleaning
Rotate the shroud fasteners (1) a quarter turn
counterclockwise.
Remove the shroud (2).
Clean the area around the air filter (3) with a damp cloth
or a soft brush.
Rotate the air filter (3) a quarter turn counterclockwise by
hand.
Remove the air filter (3).
Rinse away coarse dirt from the outside of the filter (3)
under running water.
If the air filter (3) is damaged. Install a new air filter (3).
WARNING
Cleaning agent may cause irritation if it contacts the skin or
eyes.
Observe the information supplied with the cleaning agent.
Avoid contact with cleaning agents.
In case of contact with the skin: Wash affected areas with
plenty of water and soap.
In case of contact with the eyes: Rinse eyes with plenty of
water for at least 15 minutes and seek medical advice.
Spray the outside and inside of the air filter (3) with STIHL
special cleaner or a cleaning agent with a pH value higher
than 12.
Allow STIHL special cleaner or cleaning agent to act for 10
minutes.
Use a soft brush to clean the outside of the air filter (3).
Rinse the outside and inside of the air filter (3) under
running water.
Allow air filter (3) to dry in the air.
Push the air filter (3) into place by hand and rotate it
clockwise until it engages in position.
The “STIHL” logo is horizontal.
Place the shroud (2) in position.
Rotate the shroud fasteners (1) clockwise until you hear a
click.
The shroud fasteners (1) are locked.
15.4 Cleaning the Spark Plug
Shut off the engine and engage the chain brake.
Allow chainsaw to cool down
Rotate the shroud fasteners (1) a quarter turn
counterclockwise.
0000-GXX-2952-A0
2
1
3
0000-GXX-3808-A0
3
11
3
0000-GXX-3809-A0

Table of Contents

Related product manuals