0458-786-0121-A
32
English
11 Operating the Saw
► Hold the saw horizontally and swing it into the felling cut
as far as possible.
► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of stabilizing strap.
► Move to the other side of the tree.
► Plunge the guide bar into the felling cut at the same
height.
► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of stabilizing strap.
► Insert a felling wedge. The felling wedge must match the
tree diameter and the width of the felling cut.
► Shout a warning.
► With outstretched arms, cut through the stabilizing strap
horizontally from outside at the same level as the felling
cut.
The tree falls.
11.9.9 Felling a small diameter leaner
A leaner is felled with a felling cut and holding strap. This
felling cut must be performed if the tree diameter is less than
the guide bar’s length.
► Shout a warning.
► Plunge the guide bar into the felling cut until it is visible at
the other side of the trunk, @ 11.9.5.
► Enlarge felling cut in direction of hinge.
► Enlarge felling cut in direction of holding strap.
► Shout a warning.
► With arms outstretched, cut through the holding strap from
outside at a downward angle.
The tree falls.
11.9.10 Felling a large diameter leaner
A leaner is felled with a felling cut and holding strap. This
felling cut must be performed if the tree diameter is greater
than the guide bar’s length.
► Shout a warning.
To Next Page
Loading...
