135MS 661, MS 661 C-M
No. Part Name Part No. Application
15 Service tool ZS (set) 5910 007 2201 Removing and installing
crankshaft (ignition side)
- Drilled plate 5910 893 2101 Removing and installing
crankshaft (ignition side)
- Screw sleeve 5910 893 2421 Installing crankshaft
16 Service tool AS (set) 5910 007 2222 Removing and installing crankshaft (clutch
side)
17 Test cable 5910 840 0400 Diagnosing and testing M-Tronic
18 Bluetooth USB stick 5910 840 1500 Data transfer between MDG 1 and PC
19 Clamping strap for assembly stand 5910 850 1651 Clamping machine to assembly stand
20 Flange 5910 850 4200 Leakage Test
21 Ignition system tester, ZAT 4 5910 850 4503 Testing ignition system
22 Ignition system tester, ZAT 3 5910 850 4520 Testing ignition system
23 Torque wrench 5910 890 0302 0.5 to 18 Nm
24 Torque wrench 5910 890 0312 6 to 80 Nm
25 Installing tool 12 5910 890 2212 Installing hookless snap rings in piston
26 Screwdriver 5910 890 2304 Adjusting carburetor through limiter caps
27 Screwdriver bit, T 27 x 150 5910 890 2400 IS-P screws
28 Hook 5910 890 2800 Detaching springs on clutch shoes
29 Punch-down tool 5910 890 4000 Fitting electrical wires in guides
30 Assembly stand 5910 890 3101 Holding saw for repairs
31 Puller 5910 890 4400 Removing oil seals
- Jaws (No. 3.1) 0000 893 3706 Removing oil seals
32 Puller 5910 890 4500 Pulling out limiter caps
33 Stud puller M8 5910 893 0501 Removing bar mounting stud
34 Stud puller M8 5910 890 3001 Installing and tightening bar mounting stud
35 Piston support 5910 893 5300 Supporting the piston
36 Hook 5910 893 8800 Removing pickup body
37 Installing tool 5910 893 9601 Removing and installing collar nut in
sprocket cover
To Next Page
Loading...
Need help?
General
Weight and Dimensions
