Stihl RE 281 - Fitting, Removing High-Pressure Hose

RE 271, RE 271 PLUS, RE 281, RE 281 PLUS
English
40
Machine without hose reel
Connecting the high-pressure hose
N Push high-pressure hose onto the
connector (1)
N Attach union nut (2) and screw it on
and tighten by hand
Disconnecting the high-pressure hose
N Unscrew the union nut (2)
N Pull high-pressure hose off of
connector (1)
Machine with hose reel
The high-pressure hose is already
connected.
Disconnecting the high-pressure hose
N Unroll the high-pressure hose (4)
N Pull out the spring clip (3) and pull
the high-pressure hose (4) out of
the connector
Connecting the high-pressure hose
N Push the high-pressure hose (4)
onto the connector of the hose reel
N Push the spring clip (3) down into
the connector
Connect the high-pressure to the
spray gun
N Push the high-pressure hose (1)
onto the connector (2)
N Attach union nut (3) and screw it on
and tighten by hand
Removal
N Push the coupling (4) in the
direction of the arrow and hold it
N Loosen the union nut (3) and
unscrew it from the connector in the
direction of the arrow
High-pressure hose extension
As a rule, always use only one high-
pressure hose extension – see "Special
accessories"
Fitting, removing high-
pressure hose
2
1
647BA005 KN
4
3
647BA006 KN
1
2
3
647BA022 KN
647BA023 KN
3
4