RE 271, RE 271 PLUS, RE 281, RE 281 PLUS
English
43
N Turn on water supply
NOTICE
The machine may only be switched on
when the water intake hose is connected
and the water supply has been turned
on. Otherwise the machine may be
damaged due to lack of water.
N Completely unroll the high-pressure
hose
N Turn the master switch to I – now
the machine is in standby mode
N Point the spray gun at the object to
be cleaned – never at persons!
When the machine is switched on,
voltage fluctuations that occur under
unfavorable mains conditions (high
power line impedance) may negatively
affect other connected electrical
appliances.
Trouble is not anticipated at power line
impedances less than 0.15 ohms.
Actuate the spray gun
N Direct the spray attachment towards
the object to be cleaned
N Point the rotary nozzle downwards
when starting (if fitted)
N Press the safety latch (1) in the
direction of the arrow – the lever (2)
is unlatched
N Squeeze the lever (2)
The motor stops when the lever is
released.
Standby
NOTICE
The machine must not be operated in
standby mode for more than 5 minutes.
If work is interrupted for more than
5 min., during breaks or if the machine is
left unattended, switch off the machine
at the master switch – see "Switching off
the machine".
Pressure/quantity control on the
machine
Working pressure and water flow rate
can be set on the high-pressure pump
for long-term adjustment in line with the
cleaning job concerned.
N Turn the knob (3) to set the working
pressure and water flow rate
The pressure in the high-pressure pump
is indicated by a pressure gauge (4).
Pressure control at the nozzle
The operating pressure can be infinitely
adjusted at the nozzle.
N Turn the nozzle sleeve – the
quantity of water delivered remains
unchanged
Switching On
Working
To Next Page
Loading...
