EasyManua.ls Logo

Stihl RMA 235 - Maintenance; Removing and Attaching the Blade; Sharpening and Balancing the Blade

Stihl RMA 235
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
0478-131-9541-A
20
English
13 After Finishing Work
Fold up upper part of grass catcher box (2) at handle (3)
and hold.
Hold the lower handle with the second hand.
Empty the grass catcher box.
Close the grass catcher box.
Attach the grass catcher box.
13.1 After Finishing Work
Switch off the mower, remove the activation key and
battery.
If the mower is wet: Allow the mower to dry.
If the battery is wet: Allow the battery to dry.
Clean the mower.
Clean the battery.
14.1 Transporting the Lawn Mower
Switch the lawn mower off.
The blade must not be turning.
Pull out the activation key and remove the battery.
Pushing the lawn mower
Push the lawn mower forwards slowly and in a controlled
manner.
Carrying the lawn mower
Wear work gloves made from resistant material.
If only the lawn mower is being carried:
Fold down the handlebar.
Hold the lawn mower with one hand on transport
handle (1) and the other hand on housing (2).
Lift and carry the lawn mower.
If the lawn mower and grass catcher box are to be carried
at the same time:
Hold the lawn mower with one hand on transport
handle (1).
Lift the lawn mower and carry to the side of the body.
Transporting the lawn mower in a vehicle
Secure the lawn mower upright so that the lawn mower
does not tip over and cannot move.
14.2 Transporting the Battery
Switch off the mower and remove the battery.
Make sure the battery is in a safe condition.
Observe the following points when packing the battery:
The packaging must be non-conductive.
Make sure the battery cannot shift inside the packaging.
Secure the packaging so that it cannot move.
The battery is subject to the requirements for the transport
of dangerous goods. The battery is classified as UN 3480
(lithium-ion batteries) and has been tested in accordance
with UN Manual of Tests and Criteria, Part III, sub-section
38.3.
13 After Finishing Work
14 Transporting

Table of Contents

Related product manuals