0478-131-9541-A
25
English
19 Troubleshooting
The lawn mower or battery
are damp.
► Pull out the activation key.
► Remove the battery.
► Clean the lawn mower.
► Allow the lawn mower or battery to dry.
The resistance at the blade
is too great.
► Set a higher cutting height.
► Switch the lawn mower on in lower grass.
The area around the blade
is blocked.
► Clean the lawn mower.
The lawn mower
stops during
operation.
3 LEDs illuminate
red.
The lawn mower is too
warm.
► Pull out the activation key.
► Remove the battery.
► Allow the lawn mower to cool down.
► Clean the lawn mower.
► Do not switch the lawn mower on too frequently
within a short time.
► Set a higher cutting height.
► Mow shorter grass.
The blade is blocked. ► Pull out the activation key.
► Remove the battery.
► Clean the lawn mower.
There is an electrical fault. ► Remove the battery and fit it again.
► Switch the lawn mower on.
The lawn mower
vibrates excessively
during operation.
The blade fastening screw
is loose.
► Tighten the screw.
The blade is not correctly
balanced.
► Sharpen and balance the blade.
The lawn mower
operating time is too
short.
The battery is not fully
charged.
► Fully charge the battery.
The battery service life has
been exceeded.
► Replace the battery.
The area around the blade
is blocked.
► Clean the lawn mower.
Fault LEDs on the
battery
Cause Remedy
To Next Page
Loading...
