EN
63
0478 131 8365 C - EN
Opening the flap:
Grasp the flap (1) at the lifting point (A)
and release upwards by pulling lightly.
Open the flap as far as the stop.
Closing the flap:
Carefully fold the flap downwards and
allow to engage.
15.3 Adapting the programming
The current programming can be seen in
the mowing plan or in the iMOW® app.
(Ö 11.7)
The mowing plan is calculated based on
the size of the mowing area during
installation or during the creation of a new
mowing plan.
The active times and the mowing
duration can be changed individually.
With the mow plan type Standard the
robotic mower mows and charges
precisely within the active times, with the
mow plan type Dynamic the necessary
mowing operations are automatically
distributed over the possible active times.
If required, several mowing or charging
operations can run during an active time. If
required, the edge of the mowing area can
be cut automatically at regular intervals.
(Ö 11.13)
Up to three different active times per day
are possible. (Ö 14.3)
If the robotic mower has to travel to
specific areas of the mowing area, starting
points must be defined. (Ö 11.14)
Changing the active times: (Ö 11.7)
– Additional active times for further
mowing operations.
– Adapting the time window, e.g. to
prevent mowing during the morning or
night.
– Omitting individual active times
because the mowing area is e.g. being
used for a party.
Extending the mowing duration: (Ö 11.7)
– There are areas which are not mown
sufficiently, e.g. because the mowing
area has many corners.
– Intensive grass growth during the
growing period.
– Particularly dense lawn.
Reducing the mowing duration: (Ö 11.7)
– Reduced grass growth due to heat, cold
or dryness.
Creation of a new mowing plan: (Ö 11.7)
– The size of the mowing area has been
changed.
New installation: (Ö 11.13)
– New location of the docking station.
– Initial operation on a new mowing area
15.4 Automatic mowing
● Switching on automatic
mowing:
When automatic mowing is
switched on, the Automatic
symbol appears next to the battery
symbol in the display. (Ö 11.7)
● Starting mowing operation:
With the mow plan type Standard, the
robotic mower sets off at the beginning
of each active time and mows the lawn.
With the mow plan type Dynamic, the
mowing operations are automatically
distributed between the available active
times. (Ö 14.3)
For safety reasons, the Stop button
must be pressed before opening
the flap during operation of the
robotic mower.
The opened flap can be removed
upwards from the machine. This
design is implemented for safety
reasons: this ensures that the
machine cannot be lifted and
carried by the flap.
The robotic mower can only be
operated when the flap is fully
engaged.
If the mow plan type Dynamic is
selected, not all the active times
may be necessary for optimal lawn
care under certain circumstances
(e.g. warm weather or generous
time window).
To Next Page
Loading...
