EN
65
0478 131 8365 C - EN
Lift the robotic mower slightly by the
carrying handle (1) to relieve the weight on
the drive wheels. Push the machine,
resting on its front wheels, into the docking
station.
15.7 Charging the battery
Automatic charging:
During mowing, charging occurs
automatically when the robotic mower
docks into the docking station at the end of
the mowing operation.
Starting charging manually:
● Following use in secondary areas,
return the robotic mower to the mowing
area and dock it. (Ö 15.6)
● Dock the robotic mower following
interruption of a mowing operation.
(Ö 15.6)
● If necessary, end standby mode of the
robotic mower by pressing a button.
Charging starts automatically.
Charging:
During charging, the text "Charging
battery" is displayed in the status
screen.
A plug symbol appears instead of
the battery symbol in the information
area of the display in all the other
menus.
The charging time varies and is
automatically adapted to the subsequent
period of use.
Charge state:
The momentary charge state can be
seen in the status screen when the
relevant display is selected.
(Ö 11.12)
In all other menus, the battery
symbol in the information area of
the display serves to indicate the
charge state. (Ö 11.3)
If the battery charge is too low, the
corresponding battery symbol appears.
In this case, place the robotic mower in the
docking station to recharge.
16.1 Maintenance schedule
The maintenance intervals are based on
the operating hours among other factors.
The relevant "Mowing hours" counter can
be called up in the "More - Information"
menu. (Ö 11.18)
The specified maintenance intervals must
be strictly observed.
Only charge the battery via the
docking station.
Never remove the battery and
charge it using an external charger.
In the event of charging problems,
a corresponding message appears
on the display. (Ö 23.)
The battery is only charged when
the voltage falls below a certain
value.
16. Maintenance
Risk of injury!
Carefully read the section "For your
safety" (Ö 6.), particularly the
subsection "Maintenance and
repairs" (Ö 6.9), and follow all
safety instructions exactly before
performing any maintenance or
cleaning operations on the
machine.
Activate the disabling
device prior to any
maintenance or cleaning
work. (Ö 5.2)
Disconnect the mains
plug before performing
any maintenance
operations on the
docking station.
Always wear gloves
when carrying out any
maintenance work,
particularly when working
on the mowing blade.
To Next Page
Loading...
