EasyManua.ls Logo

Stihl RMI 522 C - Page 81

Stihl RMI 522 C
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
79
0478 131 8365 C - EN
Message:
1220 – Rain detected
Mowing interrupted
Possible cause:
Mowing operation has been interrupted
or not started due to rain
Remedy:
No action necessary; adjust rain sensor
if required (Ö 11.11)
Message:
1230 – Docking error
Dock iMOW®
Possible cause:
Docking station has been located,
automatic docking not possible
Remedy:
Check docking, if necessary dock
robotic mower manually (Ö 15.6)
Check perimeter wire – ensure correct
routing in area of docking station
(Ö 9.9)
Message:
2000 – Signal problem
Dock iMOW®
Possible cause:
Wire signal faulty, fine tuning necessary
Remedy:
Place robotic mower in docking station
– then press OK
Message:
2020 – Recommendation
Annual service by spec. dealer required
Possible cause:
Machine service recommended
Remedy:
Have the annual service carried out by
a STIHL specialist dealer
Message:
2030 – Battery
Allowed operating time reached
Possible cause:
Battery replacement necessary
Remedy:
Have the battery replaced by a STIHL
specialist dealer
Message:
2031 – Charging failure
Check charging contacts
Possible cause:
Charging cannot be started
Remedy:
Check docking station and robotic
mower charging contacts and clean if
necessary – then confirm message with
OK
Message:
2032 – Battery temperature
Outside temperature range
Possible cause:
Temperature in battery during charging
too low or too high
Remedy:
Allow robotic mower to warm up or cool
it down – observe permissible
temperature range of battery
Message:
2040 – Battery temperature
Outside temperature range
Possible cause:
Temperature in battery when starting
mowing operation too low or too high
Remedy:
Allow robotic mower to warm up or cool
it down – observe permissible
temperature range of battery (Ö 6.4)
Message:
2050 – Adapt mowing plan
Extend active times
Possible cause:
Active times have been
shortened/deleted or the mowing
duration has been extended – the
stored active times are insufficient for
the necessary mowing operations.
Remedy:
Extend the active times (Ö 11.7) or
shorten the mowing duration (Ö 11.7)

Table of Contents

Related product manuals