TS 350 21
Top: Starting
Center: Throttle trigger in idle position
Bottom: Stop switch in "STOP" position
Points to observe when starting:
The choke lever is mechanically connected to the
carburetor's choke valve. The choke valve is closed when
the choke lever is on "Choke" and open when the choke
lever is moved away from "Choke".
When starting a cold engine only keep the choke lever in
the "Choke" position until the engine begins to fire. Then
move the choke lever immediately, away from "Choke",
even if the engine stops and you have to repeat the
starting procedure. If you leave the choke lever on
"Choke", the combustion chamber will flood and stall the
engine.
If you have moved the choke lever away from "Choke"
after the engine fired and the engine still does not run after
several attempts, it is already flooded. In such a case,
remove and dry off the spark plug. Clear the combustion
chamber by pulling starter rope several times with the
spark plug still removed and the stop switch in the "STOP"
position. When you now try to start, move the choke lever
away from "Choke", even if the engine is cold, and set the
throttle trigger to the starting-throttle position.
In very cold weather only open the choke sligtly after
starting-move choke lever to center position. Allow engine
to warm up for a brief period at half-throttle. Then move
choke lever away from "Choke" and disengage the
starting throttle lock.
A new engine or one which has been run until the fuel
tank is dry will not start first time after fueling because fuel
only begins to reach the carburetor when the engine has
been turned over few times on the starter
.
To Next Page
Loading...
Need help?
General
