(QJLQH
STIHL single-cylinder two-stroke engine
Displacement: 60.3 cm
3
(3.68 cu.in)
Cylinder bore: 49 mm (1.93 in)
Piston stroke: 32 mm (1.26 in)
Power: 3.0 kW (4.1 HP)
Rated spindle
speed: 5,000 r.p.m.
(make sure that the maximum operating
wheel speed is above or equal to the
rated spindle speed of your cut-off ma-
chine).
,JQLWLRQV\VWHP
Type:
Electronically controlled
(breakerless) magneto ignition
Spark plug
(interference-
suppressed): Bosch WSR 6 F
Champion RCJ 6 Y
or NGK BPMR 7 A,
Electrode gap: 0.5 mm (0.02 in)
Spark plug thread: M14 x 1.25,
9.5 mm (0.37 in)
long
)XHOV\VWHP
Carburetor:
All-position diaphragm carburetor with
integrated fuel pump
Air filter:
Prefilter, large main filter (paper filter
cartridge) and flocked auxiliary filter
Fuel tank capacity:
0.55 litres (1.2 pt)
Fuel mix:
refer to the chapter " Fuel mix".
$EUDVLYHZKHHOV
Composite abrasive wheels for steel,
stone, asphalt, ductile cast pipes
and plastics*.
Diamond abrasive wheels for stone
and asphalt.
Dia. 300 mm (12 in) or 350 mm (14 in)
2.6 to 6 mm (0.10 to 0.24 in) thick
Cutting depth approx.
100 mm (3.9 in) with
300 mm (12 in) wheel
115 mm (4.5 in) with
350 mm (14 in) wheel
* Not available in all countries
'LPHQVLRQV
Length including mounted abrasive
wheel dia. 300 mm
(12 in): 760 mm (29.9 in)
Height up to guard: 330 mm (13.0 in)
Width including
handle bar: 310 mm (12.2 in)
:HLJKW (without abrasive wheel)
with dia. 300 mm: 9.55 kg (21 lb)
with dia. 350 mm: 9.95 kg (22 lb)
$FFHVVRULHV
Set of tools
6SHFLDODFFHVVRULHV
STIHL Cutquik
TM
cart
Attachment (TS 350) for Cutquik
TM
cart
Cutting depth limiter
Water attachment for wet cutting
Water container
6SHFLILFDWLRQV
76
To Next Page
Loading...
Need help?
General
