3 Knowledge of the Truck
Numerical keypad (optional)
Numerical keypad (optional)
BAD
OM1782
Use instructions for the operator
A numerical keypad is available as an alterna-
tive to the ignition key:
• numerical keys (1 -2 -3 -4)
• confirmation key (OK)
• cancellation key (C), used to enter the
machine start-up code
When the forklift is turned off, the green LED
(A) remains lit.
When the forklift is turned on, the green LED
flashes.
The forklift is turned on by entering the four-
number user password and then pressing the
key (OK):
• if the password (Pin Code) entered is
correct, the green LED (A) begins to flash.
• if the password (Pin Code)entered is
incorrect, the red LED (B) lights up and
the numerical keypad emits an acoustic
warning signal, after which the green LED
(A) lights up and remains lit.
The forklift is turned off by pressing key (C).
The four-digit user password for the first
start-up is factory-set and is: 1234
Use instructions for the pers
on responsi-
ble for operators
The person responsible for op
erators has
a password(Master Code) that
makes it
possible to:
• memorise several personal operator pass-
words (Pin Code) for turning on the forklift.
• cancel one or more personal operator (Pin
Code) passwords
• change the password of the p
erson respon-
sible for operators (Maste
r Code)
Entering a new Master Cod
e:
• Enter the password of the person responsi-
ble for operators (Master Code) (for the first
time memorised, the password is the one
set by the factory: 111111) and press the
key (OK). The green LED (A) turns off and
the yellow LED turns on(D).
• Using the keyboard, enter the control code
’11’ and press the key (OK). The yellow LED
(D) will begin to flash.
• Enter a new six-number p
assword (Master
Code) and press the key (
OK).
WARNING
The new password (Master Code) will overwrite the
previous password.
We recommend that the person responsible for
operators change the password (Master Code)
when the forklift is delivered.
Enteringapassword(PinCode)forthe
operator
• The four-digit user password for the first
start-up is factory-set and is: 1234. We
recommend that the person responsible
for operators change this password and
personalise it as follows:
• Enter the password of the person responsi-
ble for operators (Master Code) (for the first
time memorised, the password is the one
set by the factory: 111111) and press the
key (OK). The green LED (A) turns off and
the yellow LED turns on(D).
30
45588043482 EN - 04/2016
To Next Page
