4 Use and Operation
Load Placement
0252_003-103
0252_003-104
Transporting loads
As a general rule, loads must be transported
one by one (e.g. pallets). Transporting several
loads at once is only authorised:
• If the safety requirements ar
emet
• On the orders of the supervisor in charge
The operator must ensure that the load is
properly packaged. The operator can only
move loads that have been properly packaged
and are safe and secure.
WARNING
Always drive forwards for optimum visibility.
– Only travel in the direction of the forks when
depositing a load, as visibility in this direction is
restricted.
If the load height or dimensions are likely to obstruct
theoperator’sview,asecondpersononfootmust
assist with manoeuvres in order to warn the driver
of any obstacles. In this case, driving is only autho-
rised at walking speed and with the greatest care.
Stop the truck immediately if you lose contact with
the person accompanying you.
DANGER
Lower or raise the load until there is sufficient
ground clearance.
Do not allow the load, the pallets or the container to
trail along the floor.
DANGER
When travelling and transporting the load, be aware
of the side clearance of the load, particularly when
cornering.
Avoid hitting shelving and objects in
your path.
DANGER
Danger of load tipping over
Avoid sudden starts and stops.
Approach corners slowly and carefully.
58
45588043482 EN - 04/2016
To Next Page
Loading...
