Still LTX 50 - Page 82

(5) Knob
●
Area for gripping the steering wheel with the
right hand during use
(6) Service braking button
●
When the button is pushed, service braking
is actuated
(7) Straddle or fork initial lowering button
(where present)
●
The functionality of the button depends on
the model of truck used. The operation can
be divided into two groups:
- Functionality for all trucks excluding OPX-
L 12/16/20S and LTX-FF models
- Specific functionality for OPX-L 12/16/20S
and LTX-FF models only
(7) Explanation of the functionality for all
trucks
excluding OPX-L 12/16/20S and LTX-
FF models
●
In this case, the control moves the straddles
●
On the version with the adjustable straddle,
when the button (7) is pressed, the strad-
dles lower fully to the ground
(7) Explanation of the specific functionality for
OPX-L 12/16/20S and LTX-FF models only
●
In this case, the command moves the forks
●
When the push button (7) is pressed, the
forks are lowered (the control always works
regardless of the fork height)
●
Fork movement can be stopped at any time
by releasing the push button (7). The forks
will stop in the position reached
(8) Control turret (where present)
●
Control turrets are present on the version of
the truck with an adjustable operator step
plate and/or fork lift (pallet stacker truck with
lift mast)
(9) Straddle or fork initial lifting button (where
present)
●
The functionality of the button depends on
the model of truck used. The operation can
be divided into two groups:
- Functionality for all trucks excluding OPX-
L 12/16/20S and LTX-FF models
- Specific functionality for OPX-L 12/16/20S
and LTX-FF models only
(9) Explanation of the functionality for all
trucks
excluding OPX-L 12/16/20S and LTX-
FF models
●
In this case, the control moves the straddles
●
On the version with adjustable straddles,
when the button is pressed, the forks are
raised fully to the maximum height of the in-
itial lift
(9) Explanation of the specific functionality for
OPX-L 12/16/20S and LTX-FF models only
●
In this case, the control moves the forks
●
When the button (9) is pressed, the forks
are raised (the control always works regard-
less of the fork height)
●
Fork movement can be stopped at any time
by releasing the button (9) The forks will
stop in the position reached
(10) Horn push-button
●
Press the button to operate the horn. This
device allows the driver to signal his pres-
ence when necessary.
(11) Straddle or fork initial lifting button
(where present)
●
For operation, see point (9)
(12) Control turret (where present)
●
For operation, see point (8)
(13) Straddle or fork initial lowering button
(where present)
●
For operation, see point (7)
Overview
3
Instruments and controls
72 45878043344 EN - 11/2021 - 12