Installation (Cont.)
Positioning the appliance
• Ensure that the aperture that you will be fitting the oven into is of the size
given in the Fig. 2, opposite.
• The oven must be fitted into an oven housing with the ventilation cut-outs
shown in Fig. 3 below.
• Ensure that the rear panel of the furniture housing unit has been removed.
• Ensure that the oven has been securely fixed into the housing unit. In order
to fix the oven into the housing, use the four screws (supplied) and screw
them through the oven cabinet into the housing unit (see page 15).
Ventilation requirements
Fig. 3: Ventilation and cut-out requirements for the installation of the
appliance into a standard kitchen unit
Fig. 3
Remove rear panel
from this section
85-90mm
void between
wall and rear
of support
shelf and of
cabinet base
Plinth
Minimum cut-out
200cm
2
To Next Page
Loading...
