WWW.STOREITCOLD.COM
SUPPORT@STOREITCOLD.COM
15
2019 © Store It Cold, LLC. Rev 2019-04A All Rights Reserved.
All nails used with treated lumber must be galvanized to prevent corrosion of the nails. Galvanized
nails have a rough dull silvery appearance.
PRO TIP
Starting nails in a board is much easier if the board is lying flat on a rigid surface than if you are trying
to hold it in position. Start the nails and pound them until they just break through the backside of the
board.
• Nail the treated BOTTOM PLATE to the four 92-5/8" and one 61" STUDS using two 16 penny
galvanized nails into each stud.
• Use two 16 penny vinyl-coated sinker nails per joint for the remaining nailing of the back wall
frame.
To Next Page
