WWW.STOREITCOLD.COM
SUPPORT@STOREITCOLD.COM
52
2019 © Store It Cold, LLC. Rev 2019-04A All Rights Reserved.
Now that we have the first 2" layer of insulation on the entire inside of the cooler, we will put on the
second 2" layer.
• Measure and cut two 2" sheets of R-max for both the left and right walls.
• Apply Heavy Duty Adhesive (like Liquid Nails) generously in a thick bead to the installed sheets
of insulation on the left and right walls and to the second layer.
• Move the second layer R-max in place and push tightly against the first layer of R-max to ensure
adhesion.
• Gently pound each sheet with the flat of your fist up and down and across for several minutes in
order to help ensure adhesion.
• Do not pound so hard as to leave marks on the R-max.
(continue on next page)
To Next Page
