WWW.STOREITCOLD.COM
SUPPORT@STOREITCOLD.COM
53
2019 © Store It Cold, LLC. Rev 2019-04A All Rights Reserved.
Trim the excess insulation of the door opening and to cut out the insulation over the A/C opening follow
these steps:
• Using a hand saw, carefully insert the tip of the saw flush with the door frame and start cutting
the excess insulation from top to bottom. To finish the cut, flip the saw (teeth facing up) and cut
flush against the frame going up until you reach the top part of the frame.
• Follow the same procedure on the other side of the door frame and on the top.
• From the outside back wall, use the A/C cut out on the OSB sheeting as a guide for your saw,
and follow the same procedure as in the door opening to cut the insulation out for the A/C
opening.
To Next Page
