WWW.STOREITCOLD.COM
SUPPORT@STOREITCOLD.COM
66
2019 © Store It Cold, LLC. Rev 2019-04A All Rights Reserved.
• Locate your A/C’s temperature sensor. It is the only thing attached to the front fins of your A/C.
If the A/C has a clip holding the sensor into the fins, remove both of them from the fins and then
remove the sensor from the clip.
• Install the Heater Cable by laying the red tip and air conditioner temperature sensor alongside
of each other. Using the provided aluminum foil wrap both together ensuring that they are in
contact.
• Plug the heater cable into the "Heater" port on the CoolBot.
• Let the Heater cable and A/C sensor connection hang free alongside the power cord of the A/C
• You can use a wire tie or zip tie to keep them next to the power cord
To Next Page
