WWW.STOREITCOLD.COM
SUPPORT@STOREITCOLD.COM
67
2019 © Store It Cold, LLC. Rev 2019-04A All Rights Reserved.
• Ease the fins apart to make a small gap by gently pushing a pencil between the fins in the center
of the A/C and within one inch from the bottom.
• Install one of the temperature sensors with the blue cable and black tip into the small gap by
gently sliding the sensor in place ¼” only. Route the cable sensor to allow for replacement of the
air conditioner front grill without pinching the cable. Plug the temperature sensor cable into the
"Fins" port on the CoolBot.
To Next Page
