As per legal safety requirements, anyone performing any operation on a Stormshield Network SN-range
product must know and follow the safety indications below:
To the attention of maintenance teams:
WARNING
CAUTION: DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED.
REPLACE ONLY WITH SAME OR EQUIVALENT TYPE RECOMMENDED BY THE MANUFACTURER.
DISCARD USED BATTERIES ACCORDING TO THE MANUFACTURERS INSTRUCTIONS.
Only qualified personnel from an approved maintenance center can perform operations on this component.
In the event of hardware problem with your Firewall or if one of the elements does not match its description,
please contact your certified partner.
Installing an appliance outside a rack
Your product must be equipped with its non-slip rubber feet in order to reduce the possibility of your
appliance slipping off the surface on which it has been installed.
These flexible non-slip rubber feet are to be attached to the underside of the chassis for SN500, SN700,
SN900 and SN910 models. Please refer to the chapter INSTALLATION PRECAUTIONS for further information.
Assembly in a 19” cabinet
For a racked installation, place heavier appliances in the lower section of the rack and lighter elements in the
higher section.
Refer to the chapter Installation in a 19” cabinet for details on how to install an appliance in a racking bay.
To Next Page
Loading...
