Channel Search
Press pq t u to highlight the options of choice and press OK to start the channel search.
Scan Mode Choose between Default (recommended), Blind Scan and Network and Fast
Scan
Channel Type Select Free to search Free-To-Air channels only,
Select Scramble to search Encrypted channels only, All Channels to search FTA
and Encrypted channels.
Service Type Select DTV to search Digital TV channels only, RADIO to search radio channels
only or All for a complete search.
It is recommended to use the default settings.
NOTE: Fast Scan option allows you to load pre-installed channel list from some
providers. This selection list appears when you have chosen Fast Scan and
confirm with OK button.
3.2 DVB-T/T2 installation
Terrestrial Setting
Here you only need to press OK to start searching.
All settings are automatically set by country selection you made in first step.
NOTE: If you have an active antenna, please check the user manual of the antenna
for external power supply. The TV can NOT supply power used for an active
antenna.
3.3 DVB-C installation
Cable Setting
Press pq t u to highlight your settings.
Scan type You can select Network Scan or Full. (Default Network Scan for quick search
advised).
NOTE: Full scan will have a duration of approximately 20 minutes, depending on
your cable network.
Network ID Please enter (with 0 ~ 9) the used Network ID from your provider.
Frequency Please enter (with 0 ~ 9) the main frequency used by your provider in KHz.
Symbol Please enter (with 0 ~ 9) the used Symbol from your provider. (Ks/s)
NOTE: Please check the settings for your cable system used by your provider!
Press OK to continue and to start search process.
8
To Next Page
Loading...
