Contrast Adjust the highlight intensity of the picture, but the shadow of the picture is
invariable.
Brightness Adjust the optical fiber output of the entire picture, it will effect the dark
region of the picture.
Colour Adjust the saturation of the colour based on your own preference.
Tint No function
Sharpness Adjust the peaking in the detail of the picture.
5.2.2 Colour Temperature
In this menu you can change the overall colour cast of the picture.
Press pq to select Colour Temperature, then press OK to enter a sub-menu. Press pq to select the
relevant picture effect (DEFAULT: Cold Normal Warm).
Cold lncrease the blue tone for the white.
Normal Increase the neutral colours for the white.
Warm lncrease the red colour for the white.
5.2.3 Noise Reduction
In this menu you can filter out and reduce the image noise and improve picture quality. Press pq to
select Noise Reduction, then press OK to enter a sub-menu.
Off Select to turn off video noise detection.
Low Detect and reduce low video noise.
Middle Detect and reduce moderate video noise.
High Detect and reduce enhanced video noise.
Default Set as Default.
5.3 Sound menu
Sound Mode Select your favourite sound mode for each input. Choices are Standard, Music,
Movie, Sports and Personal.
Enjoy Music Turns off the screen or switch to music source when it will be found on HDMI
input.
Auto Volume Adjust the volume corresponding to the input audio level. Options are On
and Off.
S/PDIF Type If you have connected S/PDIF output to digital home audio system. You can
select “Auto” to output Dolby audio* automatically. If channel have this audio
channel. Selection PCM is only stereo audio and Off is to switch off this output.
AD Switch Turn on the Audio description, you can activate the setting of AD volume.
When turn on the audio description, a narrator will describe what is
happening on the screen for blind or visually impaired viewers. (Only if
available in DTV mode.)
* Availability depending on broadcaster
10
To Next Page
Loading...
