6.10 PIP Function(Picture in Picture)
Ү
PIP is the feature where one program (channel) is displayed on the main screen at
the same time as another program (channel) is displayed in a smaller inset window
Ү
To activate the PIP function press the PIP button
Ү
This will bring a up Sub Channel List. From this list select the channel you wish to be
displayed in the PIP window by pressing the button. Press the button again to
remove the Sub Channel List
Ү
To change the channel displayed in the PIP window press the PIP+ button to change
the channel up, or press the PIP- button to change the channel down.
Ү
To decrease the size of the PIP window press the PIP button
Ү
To remove the PIP window (if window is at largest size) press the PIP button twice
Ү
To remove the PIP window (if window is at the reduced size) press the PIP key once
Ү
To switch between the main channel and the PIP channel press the PIP Swap button
5655
Problem
The LED light on the front
panel does not light.
No Picture or sound.
Black-and-white
screen or V-Hold.
The remote controller
is not working.
Troubleshooting
There may be various reasons for the abnormal operation of the unit. Therefore, if the unit
does not work properly, check it according to the procedures shown in the table below:
Remedy
Connect the power cord properly
into the power socket.
Connect the two terminals
correctly with RCA or HDMI
cable(s).
Connect the antenna cable
correctly.
Adjust the direction of the
antenna.
Check the cable connections,
the LNB and other equipment
connected between the LNB and
the receiver, or adjust the antenna.
Type the setting values correctly.
Use a TV of the same mode.
Connect a NTSC/PAL converter
between the receiver and the TV.
Change the batteries.
Switch off the light.
Aim the remote control at the
receiver.
Possible causes
The AC power cord is
disconnected.
Wrong connection of the
video/audio output to the
TV input terminal.
Wrong connection of the
satellite antenna cable.
Wrong direction of the
satellite antenna.
No signal or weak signal.
Wrong setting of channel
information in the MENU
screen.
Your TV mode (PAL/NTSC)
is different from the satellite
broadcasting mode.
Batteries are exhausted.
Fluorescent light is interfering
with the remote controller.
Remote controller is
incorrectly aimed.
To Next Page
Loading...
Need help?
General
