6.2 System Setting
These can be accessed by pressing the button and then scrolling to the “System”
section and pressing
N
1) Time Settings
The sub menu allows you to set your local time, wake up timer, wake up channel and
sleep time. <Figure 6.2.1>
Use the scroll buttons to select the following options
- GMT Usage : Set this ON for the local time to be determined by adjusting the time
difference with GMT.
- Current Date : If GMT Usage is OFF you can change the date by pressing
- Current Time : If GMT Usage is OFF you can change the time using the NUMERIC
buttons
- Daylight Saving : Select the time during which summer time is applied
- Local Offset : If GMT Usage is ON, local time is GMT + Local Offset
- Wake Up Mode : Selects wake up frequency (Off/Once/Daily/Mon - Fri)
- Wake Up Time : Set the wake up time using the NUMERIC buttons.
- Wake Up Channel : Press to set the wake up channel.
- Sleep Mode : Use to select sleep frequency ( Off/Once/Daily/Mon-Fri)
- Sleep Time : Set the sleep time using the NUMERIC buttons
- Timer Lead Time : Press . This will allow you to set the Lead In & Out times to
either 5, 10 or 15 minutes.
<Figure 6.2.1>
ᶀ
V.FORMAT <Figure 6.1.18>
You may select the video resolution by pressing . Available selections are 1080p,
1080i, 720p, 576p, 576i, AUTO.
ᶀ
ASPECT <Figure 6.1.19>
Pressing ASPECT changes the aspect ratio. Available ratios are:
- 4.3 Pan-Scan or Letter-Box
- 16.9 Full-Screen or Pillar-Box
6.1 Getting Started
<Figure 6.1.18> <Figure 6.1.19>
2019
ҫ
Note : Lead In and Lead Out Times can be set on your SRT 4930L to apply to all Timer recordings
To Next Page
Loading...
Need help?
General
