PART 1 • English
14
Symptom Remedy
Remote control fails to
operate receiver
Check the batteries in your remote control. Make sure your receiver is
in the operate mode. Make sure you are pointing your remote control
at the receiver’s front panel
Make sure there is no direct sunlight from behind the receiver
There may be a temporary transmission error, or your receiver has lost
some of its software settings. Switch off your receiver at the power
source and switch it on again after a few seconds
No program broadcast
recorded on VCR
Check the connection between receiver and VCR. Please make sure
your VCR is set properly
Electronic Program Guide (EPG)
EPG empty The selected program does not support EPG. The local time is
incorrect. Set the correct local time
Audio & video issues
TV Picture changes
colour
This may happen after a power-cut or disconnection from the power
source. Your receiver has lost some software settings. Switch off your
receiver and on again after a few seconds. If the problem persists,
contact your vendor
Blocks in the TV picture The signal is too weak or defective due to e.g. bad weather conditions.
Try to adjust your aerial position or wait for the signal to be re-
established
A.2 SPECIFICATIONS
Demodulator
Demodulator: COFDM; 16 QAM / 64 QAM
Transmission mode: 2 K, 8 K
Video Decoder
Profile level: MPEG-2 MP@ML
Video resolution: 720 x 576 pixels (PAL), 720 x 480 (NTSC)
Decoding & Video Out: PAL & NTSC
Aspect ratio: 4:3, 16:9
Audio Decoder
MPEG MusiCam Layer I & II
Sampling rate: 32, 44.1, 48 kHz
Audio mode: Stereo, Joint Stereo, Dual Mono, Mono
To Next Page
