PART 1 • English
9
English
n Move channel
Press the UP/DOWN keys to point the focus of the menu to the channel of your selection.
Press the LEFT/RIGHT keys to point the focus of the menu to the column “Move”. When
the focus is on column “Move”, press the OK button to confirm selection of the channel,
using the UP/DOWN buttons move the channel to its new location and press the OK
button to confirm the new location. Repeat this for every channel that you want to move.
n Delete channel
Press the UP/DOWN keys to point the focus of the menu to the channel of your selection.
Press the LEFT/RIGHT keys to point the focus of the menu to the column “Del”. When
the focus is on column “Del”, press the OK button to mark the channel as selected to be
deleted from the list. To apply the changes press the
EXIT button and confirm the channel’s
deletion.
n Delete all channels
To delete all channels from current satellite press
BLUE button (Dell All). You will be asked
to confirm operation.
5.1.2 Favorites Manager
Press the UP/DOWN keys to select the channel. Press the LEFT/RIGHT keys to point the focus
to the favorite group. Press the OK button to add the selected channel to the Favorite group. To
remove the channel from the favorite group, repeat same operation.
5.2 Installation
The installation menu contains three sub-menus; “Antenna Installation”, “Auto Scan” and “Manual Scan”.
5.2.1 Antenna Installation
You can add a satellite, edit a satellite and delete a satellite in this menu.
n Add satellite
If you want to add a new satellite, press the
RED key in this menu, a satellite list will appear
on the screen. Press
LEFT/RIGHT to select the satellite. If the satellite does not exist in the
satellite list, please select “NEW SAT1”. After selection of a satellite from the satellite list,
the Configure Antenna menu will appear, please set the LNB Type, LNB Low Freq, LNB High
Freq, Band control, Polarisation control, DiSEqC Switch and Antenna mode. Future steps of
installation are described in 4.2.
n Edit satellite
If the parameters of the satellite were changed or the satellite is a new satellite, you must
set the parameters of the satellite, such as LNB type, LNB low Freq, LNB High Freq,
Transponder, LNB Power, 22k Tone, DiSEqC and Antenna Mode. Sequence of editing of
satellite parameters is same as sequence of “Add satellite” and described in 4.2
n Delete satellite
If you want to delete a satellite, press the YELLOW key. Then a warning message will
appear. Select
OK and press the OK button to confirm.
To Next Page
Loading...
