Need help?Do you have a question about the Strong SRT 6126 and is the answer not in the manual?
Video and Audio| video resolution | 720x576 (PAL), 720/480 (NTSC) |
|---|---|
| aspect ratio | 4:3, 16:9, Pan & Scan, Letter box |
| audio mode | Stereo, Dual Channel, Mono, Joint Stereo, Mono, AC 3 |
Tuner| input frequency range | 950 ~ 2150 MHz |
|---|---|
| RF input level | -25 ~ -65 dBm |
| LNB power | 13 / 18 V DC |
Power| input voltage range | 90 ~ 240 V AC (SMPS) 50/60 Hz |
|---|---|
| power consumption | Max. 25 W |
| standby power consumption | 13 W |
Operating Environment| operating temperature | +5 ºC ~ +45 ºC |
|---|---|
| storage temperature | 0 ºC ~ +50 ºC |
System and Memory| main processor | STi 5518 |
|---|---|
| flash memory | 2 Mbytes |
| SDRAM | 8 Mbytes |
Weight and Dimensions| size | 280 x 40 x 175 mm |
|---|---|
| weight | 2 kg |
Guidance on connecting the satellite receiver to a television and VCR using SCART cables for optimal setup.
Instructions for initial receiver startup, including pre-programmed channels and satellite channel selection.
Configure LNB settings, including selecting the correct LNB type and parameters for signal reception.
Set or adjust the dish position for optimal satellite signal reception, supporting manual or automatic modes.
Select the LNB type from Universal 1-3 or Single, specifying frequency parameters.
Choose between 'Fixed' or 'Motorised' (Move) dish settings for satellite tracking.
Enable and configure the DiSEqC switch for controlling multiple LNBs or dish motors.
Select the input port for the DiSEqC switch, supporting up to 16 positions for advanced setups.
To Next Page
