Need help?Do you have a question about the Strong SRT 7500 and is the answer not in the manual?
General| Flash Memory | 8 MB |
|---|---|
| SDRAM | 128 MB |
| Ethernet | No |
| Type | Satellite Receiver |
| DVB Standard | DVB-S2 |
| Input Frequency Range | 950-2150 MHz |
| LNB Power | 13/18V |
| DiSEqC Version | 1.0/1.1/1.2/USALS |
| Demodulation | QPSK, 8PSK |
| Symbol Rate | 1-45 MS/s |
| Video Decoding | MPEG-2 |
| Aspect Ratio | 4:3, 16:9 |
| Audio Decoding | MPEG-1 Layer I & II, MP3, AAC |
| Audio Mode | Stereo, Mono |
| Input Connector | F-type |
| Connector Type | F-Type |
| TV SCART | Yes |
| HDMI | Yes |
| S/PDIF | Yes |
| USB | USB 2.0 |
| Power Consumption | max. 25W |
| Output Connector | HDMI, SCART, S/PDIF |
Detailed safety precautions and warnings for product operation and maintenance.
Explains the functions of each button on the provided remote control.
Guides on connecting the satellite dish, including fixed and motorized setups.
Instructions for connecting the receiver to a television via HDMI or SCART cable.
Provides guidance on setting up the satellite dish and adjusting signal parameters.
Detailed settings for satellite dish installation, including DiSEqC configurations.
Guides through the initial setup process, clearing existing data and settings.
How to access and use the Electronic Program Guide (EPG) for channel schedules.
To Next Page
