What to do if the standby indicator does not light up on my Strong SRT 7030?
If the standby indicator on your Strong Receiver doesn't light up, the issue might be that the mains lead is unplugged or the multipoint connector is switched off. To resolve this, check the mains lead and ensure it is properly plugged in. Also, switch the multipoint connector on.
General| Type | Digital Satellite Receiver |
|---|---|
| Tuner | DVB-S2 |
| TV System | PAL/NTSC |
| Video decoding | MPEG-2, MPEG-4, H.264 |
| Audio decoding | MPEG-1 Layer 1, 2; PCM Downmix |
| Power consumption | 15W |
| Demodulation | QPSK, 8PSK |
| Weight | 0.8 kg |
| Output | HDMI |
| Resolution | 1080p |
| LNB Power | 13/18V |
| DiSEqC version | 1.2 |
| Video resolution | 1080p |
| Aspect ratio | 16:9, 4:3 |
| Standby power | 0.5W |
| Input Frequency Range | 950-2150 MHz |
| Symbol Rate | 2-45 Msps |
| Video Output | HDMI |
| Audio Output | HDMI |
| Input voltage | 220-240 V AC, 50/60 Hz |
| Power Supply | 220 - 240 V AC ~ 50/60 Hz |
To Next Page
