Strong SRT 7030 - Multimedia

Rename a TV or radio programme
1. Select the programme you want to rename and press BLUE to enter the Edit section. Then use
GREEN and then select the programme you want rename. A pop-up appears.
2. In the pop-up select a character by using the tu buttons. Use the numeric buttons to enter
characters. When you have entered the new name press YELLOW on the remote control to
conrm the new name.
3. To store the changes and exit the menu, press  several times.
Sort a TV or radio programme list
1. Press the BLUE Edit button and select the list you want to sort with the tu buttons.
2. Press RED Sort and select the option in which order the list should be sorted.
Options are:
Name A-Z Sort on alphabetical order, beginning with A.
Name Z-A Sort on alphabetical order, beginning with Z.
Free/Scrambled Sort on type of channel, Free to Air rst in list or scrambled channels rst.
Lock Put the locked channels rst in the list.
Delete All channels
To delete all stored channels, select the Delete All function.
NOTE: To obtain channels again, you must search the satellites again from the
Installation menu.
Channel Play Type while zapping in normal viewing mode:
All All channels in the channel list Free and Scrambled will be accessible.
Free Only the Free channels in the channel list will be accessible, scrambled
channels will be ignored (skipped).
Scrambled Only the Scrambled channels in the channel list will be accessible, free
channels will be ignored.
NOTE: Scrambled channels cannot be watched with this receiver.
7.3 Multimedia
7.3.1 Media Player
PVR and Timeshift *
*This user manual describes the full functionality including the recording function and may not be applicable if the software for recording
via USB has not yet been installed.
PVR, Instant recording*
To directly record a programme, press the 4 button to start the recording, a 4 icon will show in the
top-right corner of the screen. Press 3 and conrm to quit. During a recording it is possible to press the
pq buttons or the OK and pq buttons to change to another channel on the same transponder only.
It is not possible to use the 09 buttons. When you press OK, you can see a list with the channels in one
20