PART 1 • English
5
English
6. VCR SCART Connector
To connect your receiver to your video recorder using a SCART cable. Your video signal
will now be looped through your receiver to your TV set.
7. S-Video Connector
To connect your receiver to your TV set using a S-Video cable.
8.
S/PDIF Digital audio output
Use this coaxial output to connect your receiver to the input of your digital audio amplifier.
9.
RS-232 Serial Port
This serial port can be used to connect your PC with your receiver, to download new
versions of software to your receiver.
10.
Power ON/OFF Switch
11. Power Cord
Your receiver requires a current of 90 ~ 240 V AC (Auto-selectable), 50 ~ 60 Hz +/-5%. Make
sure to check the power specification before connecting your receiver to the wall outlet.
2.3 Remote Control Unit
Turns the receiver On/Off.
Mutes audio output of the receiver.
AV Toggle between TV and AV mode
0~9 Changes channel and controls numeric functions
FAV Toggle Favorite mode ON / OFF.
TV/R Toggle between TV or RADIO mode
MENU Shows the main menu and exits from any level of menu to view mode
INFO Shows information of the current channel
EPG Shows the EPG (Electronic Program Guide) only when menu is off.
EXIT Exits from the menu or sub-menu and cancels the progressing function if applicable.
pq Change the current program to the previous/next program when menu is off.
Moves the cursor upwards/downwards when menu is on.
tu Increases/decreases the volume level when menu is off. Change the setting values
in specific menu item when menu is on.
OK Activates the highlighted menu item. Displays a channel list according to TV /Radio Mode
V+ / V- To increase or decrease the receiver volume level.
P+ / P- Page up and down in menu list.
MOSAIC Shows pictures of 9 channels simultaneously on the screen
PAUSE Freeze/Resume picture.
AUDIO Shows the list of available audio languages for the channel you are watching. In addition it
sets the current channel audio to stereo ((
n)), left-mono ((n or right-mono n)).
EDIT Program edit
REPLAY Replay last 15 seconds of current channel
TEXT Shows current service’s Teletext on OSD
SUB Show the list of subtitled languages the current channel supports.
RECALL
Switches back to last channel viewed
To Next Page
Loading...
