15
PART 2 • English
English
NOTE: If, after a software upgrade, the receiver should behave in an unexpected
way, please perform a factory reset as well. Restore Factory Default. See
chapter 7.8.2.
WARNING! After an update the receiver restarts automatically. During the upgrade
process NEVER disconnect the receiver from the mains or switch off the
power! Doing so might damage your receiver and will void warranty!
7.9 Media
The Media menu consists of the following submenus: Media Player, Photo Configure, Movie Configure
and PVR Configure.
Use pq to highlight the sub menu of choice and press OK to enter. Press EXIT to quit.
7.9.1 Media Player
This function allows playback of different kind of files from the connected USB storage device. In the
Media menu, select Media Player and press OK to enter this menu. Press tu to select the media type
of your choice and press OK. Select with tu and OK to open the directory respectively its folders/
subfolders. Press RECALL to move back up one folder. Select which file you like to play. Press OK to
start playback of the file. Press the EXIT button to exit.
Throughout the media player the 7 8 and 5 6 buttons can be used were applicable. Also 2 and
1. INFO will show technical details of the file shown. Other possible functions are displayed in the
bottom line on screen.
Music: If a folder/files are selected, it is possible to return to Photos and have the
music in the background.
Video: Press RED to toggle between preview window and full screen play. Use the
0~9 buttons to jump 10 to 90% in time.
Photo: Press ZOOM and tu to zoom in on certain areas of the picture. Press 1 to
start a slideshow. Press BLUE to have an overview of your pictures as ‘Grid
show’.
PVR: Own recordings are stored in the HBPVR folder.
Photo Configure: Select your preferences for picture view, as Slide Time, Slide Mode and aspect
ratio handling of the pictures.
Movie Configure: Select your preferences for subtitles, as size, background and font colour.
PVR Configure: Record Device. This option shows technical information about the connected
USB device. Select the relevant partition with tu, if applicable. Select the
amount of gigabytes you want to dedicate to timeshifting. (Default 1GB.)
Format: If your USB device is not formatted yet, it can be done here. Press OK to enter
the format menu. It is only possible to format in FAT32, however, it is possible
to use an already NTFS formatted HDD for recording and storage. Press OK to
format the connected USB device. Enter your PIN code to continue (DEFAULT
PIN: 1234) and press OK to start formatting or EXIT to leave without
formatting.
To Next Page
Loading...
