EasyManua.ls Logo

Stryker Endoscopy 1088 - Page 6

Stryker Endoscopy 1088
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
8. Never sterilize the camera console.
9. Disconnect the control unit from the electrical outlet when
inspecting the fuses.
10. Read the entire instruction manual before assembling or
connecting the unit.
11. Before each use, check the outer surface of the endoscope
to ensure that there are no rough surfaces, sharp edges, or
protrusions.
The warranty is void if any of these warnings is disregarded.
Stryker Endoscopy accepts full responsibility for the effects on safety,
reliability, and performance of the equipment only if:
Readjustments, modifications, and/or repairs are carried out
exclusively by Stryker Endoscopy.
The electrical installation of the relevant operating room complies
with the applicable IEC, CEC, and NEC requirements.
Stryker Endoscopy reserves the right to make improvements to the
product(s) described herein. Product(s), therefore, may not agree in detail
to the published design or specifications. All specifications are subject to
change without notice. Please contact the local Stryker Endoscopy
Distributor listed in the Other Service section, or phone your local Stryker
Endoscopy sales representative or agent for information on changes and
new products.
Warning Federal law (United States of America) restricts this
device to use by, or on order of, a physician.