Stryker Endoscopy 1088 - Setting up the 1088 Camera; Setting up the Console

12
Note Stryker Endoscopy considers instructional training, or in-
service, as an integral part of the 1088 Medical Video
Camera. Your local Stryker Endoscopy sales
representative will perform at least one in-service at your
convenience to help set up your equipment and instruct
you and your staff on its operation and maintenance. To
schedule an in-service, contact your local Stryker
Endoscopy representative after your equipment has
arrived.
Setting Up the 1088 Camera involves three steps:
1. Setting up the console
2. Setting up the camera head
3. Setting up the coupler
Setting Up the Console
Caution Portable and mobile RF communications equipment may
affect the normal function of the 1088 Camera. When
choosing a location for the 1088 Camera, consult the
“Electromagnetic Compatibility” section of this manual to
ensure proper function.
To set up the console, make the following connections:
1. Connect the AC power.
• Connect the AC power cord to the AC inlet on the rear console
panel.
• Connect the other end to a hospital-grade outlet.
Warning Always use the hospital-grade power cord supplied
with this camera.
Setting Up the 1088 Camera