Stryker 1015 - Litter Corner Cover Replacement; Gatch Release Handle Replacement; Gatch Valve Body Replacement

Service Information
16
LITTER CORNER COVER REPLACEMENT
Required Tools:
Drill w/ 1/4” Bit T25 Torx Utility Knife
1. Drill out the rivet holding the IV pole and/or push handle in the socket and remove the IV pole/handle from
the socket.
2. Using a utility knife, pry off the three hole plugs in the top of the cover.
3. Using a T25 Torx, remove the 3 screws holding the top and bottom covers together and pull apart the
cover.
4. Reverse to install the new cover.
GATCH RELEASE HANDLE REPLACEMENT
Required Tools:
Needle Nose Pliers
1. Twist off the Gatch release handle knob.
2. Using needle nose pliers, remove the cotter pin holding the Gatch release rod to the Gatch release link.
3. Pull out the handle release rod.
4. Reverse to install the new Gatch release handle assembly.
GATCH VALVE BODY REPLACEMENT
Required Tools:
1/2” Socket 3/8” Drive Ratchet Needle Nose Pliers
1. Using needle nose pliers, remove the rue clip and clevis pin connecting the Gatch pump ram to the pump
handle.
2. Using a 3/8” drive ratchet and a 1/2” socket, remove the three hex head bolts holding the Gatch valve
body to the Gatch weldment and the lock nut holding the release link. Carefully lower the valve body out
of the weldment.
3. Using needle nose pliers, remove the two rue clips and two clevis pins connecting the hydraulic cylinder
to the seat section and the thigh section. Remove the valve body assembly.
4. Reverse to install the new Gatch valve body assembly.
Return to Table of Contents