Siderail Operation Guide
13
POSITIONING SIDERAILS
NOTE
The siderails can be locked at two heights (intermediate & full).
The siderails can be tucked away under the bed when not in use.
To remove the rail from the tucked position, grasp at the top of the
rail and pull outward.
To engage the siderail, grasp the rail and push it
upward until it rests in the ”intermediate” position.
To continue to the full height, pull the brown
release handle (A) until full height is
reached.
WARNING
Be sure rail is locked securely
into position. Siderails are not
intended to keep patients from
exiting the bed. They are
designed to keep a patient
from inadvertently rolling off the
bed. Proper restraint methods
should be utilized to ensure the
patient remains in bed.
To disengage the rail, pull the brown release handle and pivot rail down to desired height. Tuck away siderails
by pushing the rails under the bed. Rails must be in the full down position before they can be tucked.
SIDERAIL CONTROL PANEL LIGHTS
The bed is equipped with lights that will illuminate the head end siderail control panel and can be activated
at the foot board control panel (see control panel guide page 10).
A
To Next Page
Loading...
