English
EN
1-6 2971-209-001 REV C www.stryker.com
Introduction
Specifications (Continued)
Electrical requirements
ANSI/AAMI ES60601-1:2005/(R)2012
and A1:2012, C1:2009/(R)2012 and
A2:2010/(R)2012
CAN/CSA-C22.2 No. 60601-1 (2008)
120VAC 50/60Hz, 2.5A
Power cord
3 foot, 16 AWG cord with hospital grade plug for use with the InTouch foot end
auxiliary power outlet
Low Air Loss flow rate
100 LPM
Leakage current 300 uA Maximum
Noise level 50 dBA maximum
Stryker reserves the right to change specifications without notice.
Environmental conditions
Operation Storage and transportation
Ambient temperature
86 °F
(30 °C)
50 °F
(10 °C)
140 °F
(60 °C)
-40 °F
(-40 °C)
Relative humidity (non-condensing)
Atmospheric pressure
See the InTouch manual for bed specifications.
Contact information
Contact Stryker Customer Service or Technical Support at: 1-800-327-0770.
Stryker Medical
3800 E. Centre Avenue
Portage, MI 49002
USA
To view your operations or maintenance manual online, see https://techweb.stryker.com/.
Have the serial number (A) of your Stryker product available when calling Stryker Customer Service or Technical
Support. Include the serial number in all written communication.
Serial number location
The serial number (A) for your support surface is located on the patient right side of the foot box on the specification
label. Unzip the support surface top cover (see Cover replacement, top on page 1-20).
To Next Page
Loading...
Need help?
General
