Stryker Isolibrium 2971 Operation Manual

English
EN
1-14 2971-209-001 REV C www.stryker.com
Operation
Positioning a patient on the support surface (Continued)
To position the patient:
1. Max Inflate the support surface.
2. Position the patient in the center of the support surface, align the patient’s head toward the head board (Figure 1-
4 on page 1-14).
3. Check the patient frequently during Lateral Rotation for proper positioning and support surface inflation (Figure 1-
5 on page 1-14 and Figure 1-6 on page 1-14).
Figure 1-4: Center the patient
Figure 1-5: Correct patient positioning
Figure 1-6: Incorrect patient positioning
Managing incontinence and drainage
WARNING
Always monitor the patient condition at regular intervals for patient safety.
You can use disposable diapers or incontinence pads to manage incontinence. Always provide appropriate skin care
after each incontinence episode.
Activating and resetting CPR
When you activate for CPR, the system deflates and the InTouch control display will change.
WARNING
Always make sure that the operator has access to the CPR straps.
To activate for CPR, pull the red CPR strap straight out from the support surface (Figure 1-7 on page 1-15). The CPR
straps are located on the left and right side of the foot end of the support surface. You can activate either one or both
CPR straps.

Stryker Isolibrium 2971 Specifications

General

Brand	Stryker
Model	Isolibrium 2971
Category	Medical Equipment
Language	English